Setting Up Fingerprint Lock on Your Smart Meble Table
This guide will walk you through setting up fingerprint access for your Smart Meble table’s drawer.
Before you begin:
Ensure the drawer is unlocked. If it’s locked upon receiving the table, follow the temporary unlocking method in Step 1.
Have 3 AAA Alkaline batteries readily available.
Step 1: Temporary Unlock (if drawer is locked initially)
Locate the small Type-C port on the fingerprint lock panel (usually on the drawer front).
Insert a Type-C charger (like the one you use for your phone) into this port.
While the charger is plugged in, gently touch the fingerprint lock sensor with any finger. The drawer should automatically unlock.
Step 2: Install Batteries
Open the unlocked drawer completely.
Locate the battery compartment behind the fingerprint lock panel (usually accessible from inside the drawer).
Insert 3 AAA Alkaline batteries according to the correct polarity markings (+ and -).
Step 3: Enroll Your Fingerprint
Ensure the drawer is closed.
Gently touch the fingerprint sensor with the finger you want to register.
Hold your finger on the sensor until the green light stops blinking and stays solid. This indicates successful registration of the first fingerprint attempt.
Once you remove your finger, the green light will turn blue.
Repeat Step 3: Place the same finger on the sensor again, using a slightly different angle (like you would when unlocking your phone). The green light should stay solid again, confirming successful registration from another angle.
Step 4: Setting Complete (Optional)
The green light will start blinking again, indicating the system is ready to register another fingerprint (if desired).
You can repeat Step 3 to enrol additional fingerprints
If you only want to use one fingerprint, simply ignore the blinking light and proceed to use the drawer with your registered fingerprint.
Step 5: Using the Fingerprint Lock
From now on, the drawer will only unlock when you touch the sensor with your registered fingerprint(s).
